Araldite on the side of the angels

Keen gardener Roddy Clenaghan noticed his resident angel had apparently suffered a crash landing - result, one broken wing.

Just hours later the cherubic guardian was back on duty, courtesy of Araldite Standard adhesive.




Araldite® Standard is one of the brands trademark high strength epoxy products. With good gap filling properties and a temperature tolerance of -30 oC to 65oC it's ideal for this job.

Here's how the repair was made.





Brush loose particles and dirt off both parts to be bonded.








 Araldite® Standard packaging is eco-friendly and easy to use - just slip the blister free of its backing card






The double-barreled syringe pack has some smart features; break off the cap and just one plunger delivers equal amounts of resin and hardener.





There is an integral re-closure cap to keep the adhesive in good condition and a snap-off mixing spatula






Resin and hardener are thoroughly mixed in seconds






Araldite® Standard was applied to both surfaces and the wing then attached using firm pressure for about 30 seconds.








Maximum bond strength is achieved in 14 hours - and the angel is restored to glory.





Please note that the information and suggested application uses on this website are published for general information purposes only.  We do not make any warranties about the completeness, reliability or accuracy of this information.  Any action that you take based on the information on this website is at your own risk. We will not be liable for any losses and/or damages in connection with the use of our products.

While ARALDITE RAPID does not contain any highly toxic components, it also does not meet the very strict standards required in order to be considered an acceptable food contact material in the EU. Thus we cannot support using a mug glued with ARALDITE RAPID.  



Copyright © 2022 Go-Araldite®. All Rights Reserved.
Joomla! is Free Software released under the GNU General Public License.