Pinecone wreath

Materials:
• Araldite Rapid
• Wireframe (10" - 14")
• Pinecones (approximately 20)
• Twine
• Glitter spray
• Tinsel
• Wreath holder

 

Find a safe and aired place to spray your pinecones. Alternatively, you could cut a side down from a cardboard box and place the pinecones inside to spray.

 

 

 

 

 

 

 

 

Spray the pinecones from approximately 30cm away.

 

 

 

 

 

Once finished, leave to dry.

 

 

 

 

 

Take your wireframe and wrap the twine/string around it so there are no gaps. Once completed, cut the twine.

 

 

 

 

Begin to glue the pinecones to the wreath, alternating the big and small pinecones next to each other.

 

 

 

 

Once the wireframe is covered in pinecones, wrap the tinsel around, making sure to weave it between any gaps between the pinecones.

 

 

 

Once wrapped, glue the end of the tinsel to secure it.

 

 

 

 

 

Finally, hang your wreath on your door with a wreath holder.

 

 

 

 

 

Please note that the information and suggested application uses on this website are published for general information purposes only.  We do not make any warranties about the completeness, reliability or accuracy of this information.  Any action that you take based on the information on this website is at your own risk. We will not be liable for any losses and/or damages in connection with the use of our products.

While ARALDITE RAPID does not contain any highly toxic components, it also does not meet the very strict standards required in order to be considered an acceptable food contact material in the EU. Thus we cannot support using a mug glued with ARALDITE RAPID.  

 

Copyright © 2020 Go-Araldite®. All Rights Reserved.
Joomla! is Free Software released under the GNU General Public License.